6
Step 1). Attach the DMX cable to the upper “in” female connector located on the back of
the hazer.
Step 2). The DMX address is configured by adding the dip switch numbers together to
total the number required. For example, DipSwitch 1 + 6 = 33. Your DMX channel would
be 33.
Dip Switch
1
2
3
4
5
6
7
8
9
Channel #
1
2
4
8
16
32
64
128
256
When you move the slide control or digital control;
0 – 5%
= Off
5– 80%
= Volume Control
80 – 100%
= Maximum Blast Output
“Input” and “Output” designations on the DMX plugs are arbitrary (i.e., you can use the
input plug for output and vice-versa). It is not necessary to attempt converting your DMX
line’s connector to female/male to match the appropriate socket on the plug. As long as it
is looped in/out, it will work.
Once your hazer is warm and the green “READY” light is on, you can control the haze
output from the control booth.
5.6
Rest Period
Continuous operation of the HazeMax™ can be accomplished when OUTPUT is set at
the 3 o’clock position. If the unit cools down when operating at the 100% / Blast setting,
a 3-minute rest period for reheating is necessary.
5.7 Troubleshooting
1.
If the pump does not draw fluid
into the hazing unit, check electrical power to the
machine. Be sure the unit is warm and ready to operate. Then check to see that the
tubing is in the fluid, not above the fluid. Check to hear any sound coming from the unit.
A slight vibrating sound should be heard if the pump is pumping fluid.
Note: Do not run
the pump without fluid passing through the tube. This can cause damage to the
pump and is not covered under warranty.
2.
If the green “READY” light does not come on
after warm-up, this may indicate that the
unit has overheated. This may happen if there is not enough air circulation or if it is in a
closed area. The machine needs to be air cooled if this occurs. If the green READY light
stays off, this indicates the heat safety breaker has released. It will not reset until the unit
has cooled to 169
o
F (76
o
C), at which time you can reset the breaker and it will be ready
to use again. Plug in the unit and warm it up again. The green READY light should
come on after 10 minutes. Call your dealer if this does not solve the problem.
