Cissell MANCONS, Руководство пользователя

Страница: 9 / 29

Page 8
REVOLVING FORM ADJUSTMENT
If the Revolving Form drags on the base rather than turning freely, it must be raised. First remove
the form by lifting it straight up off the base. Then loosen the Bearing Locknut and turn the Bearing
Adjustment Screw counter-clockwise . Check adjustment by replacing form and rotate. Repeat
adjustment if needed.
If Revolving Form is too high above base, steam will escape from between the base and the bottom of
the form. To correct, first remove form from the base. Then loosen the Bearing Locknut and turn the
Bearing Adjustment Screw clockwise . Replace form on the base and check adjustment. Repeat if
needed.
MAINTENANCE RECOMMENDATION
Change the air filter located on the rear of the machine at least every six months depending on the use
and environmental conditions. See the parts section of this manual for the replacement part number.
SERVICE CHART
REMEDY
See item 4.
Inspect and repair or replace
leaking part.
Remove foreign object.
Inspect wheel for loose weights, out
of round or damage. Repair or
replace as needed.
Tighten set screws on wheel hub.
Repair or replace as needed.
Repair or replace as needed.
Reset timer.
Reset timer.
Open damper; check damper
control linkage and reapir or
replace as needed.
Check fuse on back of control,
replace if needed.
Check for steam or water leaks.
Dry out control.
Replace timer control.
CAUSE
A. Wet steam.
B. Steam leak in machine.
See items 3, 4, and 8.
A. Foreign object in blower.
B. Wheel out of balance.
C. Wheel loose on shaft.
D. Motor mount bent.
E . Motor bearings bad..
See items 1A, 1D, or 11.
Timer set too long.
See item 11.
Timer set too long.
See item 11.
A. Damper is closed.
See items 2 and 11.
A. No power on control.
B. Moisture accumulated.
C. Timer control bad.
PROBLEM
(5) Water inthe base.
(6) Noisy or vibration.
(7) Not enough steam.
(8) Too much steam.
(9) Too much air.
(10) Form will not inflate.
(11) Timer control does not
function.