Cissell AJ1032, Руководство по эксплуатации и техническому обслуживанию

Страница: 18 / 22

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Maintenance
AJ1032 16
Lubrication
Lubrication points are illustrated in Figure 3 .
Lubrication points, time intervals, types and services
are listed in
Table 3 .
If complete details for lubrication services are not
listed in
Table 3 , get detailed instructions from
referenced paragraph.
To avoid possible serious injury, ALWAYS
close air supply line shut-off valve AND
lock out air service BEFORE performing
lubrication services.
W347
WARNING
Lubrication Point Time Interval Type of Lubricant Lubrication Service
NOTE: FAILURE to use correct lubricants can result in DAMAGE to machine mechanical components as well as air
system cylinders and valves.
(A) Pressure arm shaft
bearing and cylinder head
bearing Every three months Use a premium high
temperature EP2 grease. Lubricate with one shot of
grease from a low pressure
grease gun. If rod end fittings
do not have grease fittings,
squirt a few drops of oil on
rod ends.
(B) Pivot pins, rod ends and
cylinder shaft Every three months ISO VG 32 grade oil. Squirt a few drops of oil
around circumference of each
shaft.
(C) Air line lubricator As required ISO VG 32 grade oil. Fill bowl to 3/4 full when
level drops below 1/4 full.
Refer to
Adjusting Air Line
Lubricator Flow Rate .
(D) Air cylinder Every month ISO VG 32 grade oil. Remove air line at bottom of
cylinder. Prime oil can and
give one complete squeeze
into air line.
NOTE: Buna-N seals are used extensively throughout the valves and cylinders in the air circuit downstream
from the inline oiler. Oils containing graphite fillers, detergent, etc., and fire resistant and synthetic oils are
NOT COMPATIBLE with Buna-N seals. Seal swelling and valve malfunctioning will result with use of
IMPROPER OILS.
Table 3