Cisco WAP351 Quick Start Guide
5
S
TEP
7
Slide the Cisco WAP351 into the bracket, placing the cable
through the break-out tab found in the back of the bracket. Mount
the Cisco WAP351 with the back panel facing up or facing down.
Connecting the Cisco WAP351
The default configuration of the Cisco WAP351 has the Wi-Fi radio turned
off.
You must perform the initial configuration using a wired Ethernet
connection.
To connect the Cisco WAP351 to the wired network:
S
TEP
1
Connect the Ethernet cable to the Ethernet port of a switch, a router,
or a PC.
S
TEP
2
Connect the other end of the network Ethernet cable to the
Ethernet port of the Cisco WAP351.
S
TEP
3
The power adapter is sold separately for the Cisco WAP351. If PoE
is not provided, connect the power adapter (48V/1.25 A) to the 48V
DC jack. For more information about the power adapter, see
www.cisco.com/go/wap_accessories
.
After installation, all lights should be active. Refer to
“Verifying the
Hardware Installation”
for details about the different lights on the Cisco
WAP351.
4
