Cisco UCS C260, Инструкция по установке и обслуживанию

Страница: 24 / 114

2-6
Cisco UCS C260 Server Installation and Service Guide
OL-24342-01
Chapter 2 Installing the Server
Installing the Server In a Rack
d.
Pull the inner slide rails on each assembly out toward the rack front until they hit the internal stops
and lock in place.
Step 2
Insert the server into the slide rails (see Figure 2-3 ):
Caution This server weighs approximately 83 pounds (38 kilograms) when fully loaded with components. We
recommend that you use a minimum of two people when lifting the server. Attempting this procedure
alone could result in personal injury or equipment damage.
a. Align the inner rails that are attached to the server sides with the front ends of the empty slide rails.
b.
Push the server into the slide rails until it stops at the internal stops.
c. Push in the slide rail locking clip (item 2) on each inner rail, and then continue pushing the server
into the rack until its front flanges latch onto the rack posts.
Figure 2-3 Inserting the Server Into the Slide Rails
Step 3
Attach the (optional) cable management arm (CMA) to the rear of the slide rails (see Figure 2-4 ):
Note The CMA is reversible left-to-right.
a.
With the server pushed fully into the rack, insert the CMA tab labelled OUTER RAIL (items 1 and
6) into the clip inside the rear of the outer slide rail. Insert the tab into the clip until it clicks and
locks.
b.
Pull outward on the spring-loaded peg that is on the CMA tab labelled INNER RAIL (items 2 and
5). You can turn this peg 90 degrees to lock it in the open position.
c.
Push the CMA tab labelled INNER RAIL over the end of the inner rail that is attached to the server,
and then release the spring-loaded peg. The peg must align with and enter the hole in the inner rail
to lock the CMA in place.
1 Inner rail attached to server 3 Slide rail assembly on rack post
2
Slide rail locking clip
4
Right-front rack post
1
2
3
4
330534