show controllers cable-modem tuner
Troubleshooting Tips for the Cisco uBR904 Cable Modem 47
show controllers cable-modem tuner
To display the settings for the upstream and downstream tuners used by a Cisco uBR904 cable
modem, use the show controllers cable-modem tuner command in privileged EXEC mode.
show controllers cable-modem tuner
Syntax Description
There are no key words or arguments for this command.
Command Mode
Privileged EXEC
Usage Guidelines
This command first appeared in Cisco IOS Release 11.3 NA.
Examples
The cable modem’s tuner settings are displayed in the following example. See Table 9 for output
field possibilities and descriptions.
uBR904#
show controllers cable-modem 0 tuner
Tuner: status=0x00
Rx: tuner_freq 507000000, symbol_rate 5360736, local_freq 11520000
snr_estimate 17488, ber_estimate 0, lock_threshold 26000
QAM not in lock, FEC not in lock, qam_mode QAM_64
Tx: tx_freq 20000000, power_level 0x3E, symbol_rate 1280000
Table 9 describes the fields shown in the display
Table 9
Show Controllers Cable-Modem Tuner Field Descriptions
Field
Description
tuner_freq
Indicates the current downstream frequency.
symbol_rate
Indicates the downstream or upstream symbol rate in use.
local_freq
Frequency on which the transmitter and tuner communicate.
snr_estimate
Signal to noise estimate in dB X 1000.
ber_estimate
Bit error rate estimate (always 0).
lock_threshold
Minimum signal-to-noise ratio (SNR) that the uBR904 will accept as a valid lock.
QAM
status
Indicates if QAM/FEC lock has been acquired and the modulation mode in use.
tx_freq
Upstream frequency sent to the uBR904 by the CMTS in the UCD message.
power_level
Transmit power level as set in the hardware, given as a hexadecimal value. The units are
unique to the hardware used. Use the show controllers cable-modem 0 mac state
command to see the power level in dBmV.
Содержание uBR904
Страница 62: ...What to do Next 62 Cisco IOS Release 12 0 3 T ...