— 3 —
A
Connecting the touch screen via LAN
1.
Restart the codec before you proceed with the installation.
2.
Connect the touch screen cable to the Power adapter.
3.
Connect the shielded Ethernet cable between the Power adapter and the LAN
(Ethernet) socket.
4.
Connect the supplied power cable between the Power adapter and the power
socket. Once power is connected, the touch screen start-up procedure begins.
Wait while the touch screen initializes. Continue when the
Select codec to pair
with
window appears. This may take a few minutes.
7.5 m
5 m
Power
adapter
Power socket
LAN socket
(Ethernet)
1.8 m
Connecting the Cisco TelePresence Touch 8”
The Touch 8” can be connected to a range of Cisco TelePresence codecs.
There are two options how to connect the Touch controller to the codec. In both
cases the connection is via the provided power adapter, as shown in the illustrations.
A.
Connecting the touch screen to a codec via LAN (local area network).
B.
Connecting the touch screen directly to the codec. To be able to use this option
you need a codec with two LAN connectors.
Codecs and systems using TC software must run version TC4.1 or later.
Note:
The touch screen obtains its IP settings automatically from the network
(DHCP). In most cases this is preferred and you can continue with the pairing.
If you need a static IP address for your touch screen perform the steps described in
the
section on page 6, before continuing.