24
Start up the system
78-100254-03A0 | 2016 JUNE | © 2016 Cisco Systems, Inc. All rights reserved.
Installation guide for Cisco TelePresence MX700 Single camera - Wall mount
Page 30
•
Remove the protection foil from the displays.
•
Make sure that the camera can move freely.
•
Insert the network and power cables into the wall outlets.
•
Switch on the system.
The power switch is located directly below the codec, next to the
power connector.
Wait a few minutes while the system starts up. The start-up may
include automatic software upgrade and restart of Touch 10 and
camera.
If the right monitor does not turn on after the start-up sequence,
check that the power cable between the monitors are properly
connected (refer to step 10 and step 12).
•
Follow the instructions on the Touch controller.
Cisco Spark: To find more information on how to get started with
Spark registered systems, visit
http://help.ciscospark.com
and look
for Getting Started articles for room systems.
Other services: For further information on set-up and configuration,
download the Getting Started Guide from the Cisco web site,
http://www.cisco.com/go/mx-docs
