Multichannel STM-1 Port Adapter for the Cisco 7500 Series Router
tug-2 e1 clock source
35
12.0(14)S
tug-2 e1 clock source
To set the clock source on an E1 line that has been mapped to a TUG-3, use the
tug-2 e1 clock source
configuration controller tug-3 command.
To set the clock source on an E1 line that has been mapped to an AU-3, use the
tug-2 e1 clock source
configuration controller au-3 command.
tug-2
tug-2 number
e1
e1-number
clock source
{
internal
|
line
}
Syntax Description
Defaults
Clock source is configured from the E1 line.
Command Modes
Configuration controller tug3 (for an E1 line mapped to a TUG-3)
Configuration controller au3 (for an E1 line mapped to an AU-3)
Command History
Usage Guidelines
Use the
tug-2 e1 clock source
command in configuration controller tug3 command mode to configure
the clock source of an E1 line that has been mapped to a TUG-3 via the
aug-mapping au-4
command.
Use the
tug-2 e1 clock source
command in configuration controller au3 command mode to configure
the clock source of an E1 line that has been mapped to an AU-3 via the
aug-mapping au-3
command.
Examples
The following example configures E1 line 1, that has been mapped to a TUG-3 to use the PA-MC-STM-1
as the clock source:
Router(config)# controller sonet 2/0/0
Router(config-controller)# aug mapping au-4
Router(config-controller)# au-4 1 tug-3 2
Router(config-ctrlr-tug3)# tug-2 4 e1 1 clock source internal
The following example configures E1 line 1, that has been mapped to an AU-3, to be the clock source:
Router(config)# controller sonet 2/0/0
Router(config-controller)# aug mapping au-3
Router(config-controller)# au-3 1
Router(config-ctrlr-au3)# tug-2 4 e1 1 clock source line
tug-2 number
A number in the range of 1 to 7.
e1-number
A number in the range of 1 to 3.
internal
Specifies the PA-MC-STM-1 as the clock source.
line
Specifies the E1 line as the clock source.
Release
Modification
12.0(14)S
This command was introduced.
