30
WiMAX configuration
SE680 WiMAX / engbt / SE680_FUG_EN-7 / Advanced_configuration.fm / 13.5.11
Schablo
ne 2005_05_
02
Assigning static IP addresses to individual PCs
Even if you have activated the DHCP server, you can still assign a static IP address to
individual PCs (e.g. when setting up these PCs for NAT functions).
Enter the
MAC address
of the PC to which you want to assign a static IP address
and the
IP address
you wish to assign to the PC.
Configuring the local network in Bridge operating mode
In
Bridge
operating mode (
page 24) the SE680 WiMAX DHCP server is deactivated.
The network components get their IP addresses from a DHCP server in the public net-
work.
WiMAX configuration
On this page you enter the data for authentication of your device on the WiMAX base
station. You will need the access data supplied by your WiMAX operator for this.
If you have executed the Basic Setup Wizard, you will already have entered these
details there. If necessary you can change them here.
Open the
Advanced Settings
tab and select
WiMAX configuration
from the
menu.
Select
Authentication
, if authentication is required by your WiMAX operator and
enter or change the required access data.
Ageing time for
MAC table
When a PC in the network is accessed, your SE680 WiMAX writes the
MAC address and port number in a MAC table to speed up further
accesses. The entry in the MAC table is deleted after a fixed time. If
necessary you can change this value via the
MAC table ageing time
parameter.
Protection
against DoS
attacks
DoS (Denial of Service) attacks are attacks on a system in the net-
work to make its services unusable. This is basically done by over-
loading the system by constantly sending requests. In Bridge mode,
the SE680 WiMAX provides protection against DoS attacks, which
you can enable or disable via the
activate DOS protection
parame-
ter.
Содержание SE680 WiMAX
Страница 2: ......