3
Cisco Smart+Connected 7" In-wall Display Reference Guide
OL-27263-01
Package Contents
Note
Video intercom using 802.11b is not recommended or supported for video intercom. We recommend
Wireless-N for video intercom. See “Wireless Network Limitations” and “Power and Network
Installation Options.”
Package Contents
Carefully unpack the Cisco In-wall Display and ensure the following items are included in the box.
Caution
Do not apply excessive pressure to the touchscreen display during handling. Doing so can crack the
screen and damage the touchscreen.
•
Cisco In-wall Display with camera
•
Power box (used to power the touchscreen)
•
Two (2) screws to attach the power box
•
Warranty card
Requirements
To install the Cisco In-wall Display, the following is required:
•
A Cisco Controller fully installed and configured.
•
A custom Back Box installed. See the
“Back Box Options” section on page 4
.
•
If using Ethernet with PoE power:
–
Ethernet network installed and available that includes a gateway/router/switch.
–
A third-party PoE Injector or switch (certified to UL/ANSI standards).
–
Two (2) Ethernet CAT5 cables: (1) one that runs from the Ethernet gateway/router/switch to the
PoE Injector/switch and (2) one that runs from the PoE Injector/switch to the Ethernet
connection in the touchscreen’s Back Box.
•
If using Ethernet with AC power:
–
Ethernet network installed and available that includes a gateway/router/switch.
–
Access to in-wall AC power (a neutral connection is required).
–
One (1) Ethernet CAT5 cable that runs from the Ethernet gateway/router/switch to the
touchscreen.
–
A 14-gauge electrical wire long enough to pull between the touchscreen and the power source.
•
If using wireless with AC power:
–
Wireless network (Wi-Fi 802.11 b/g/n) installed and available with a wireless access point
(WAP).
–
Access to in-wall AC power (a neutral connection is required).
–
A 14-gauge electrical wire long enough to pull between the touchscreen and the power source.
