15
Cisco Smart+Connected 7" In-wall Display Reference Guide
OL-27263-01
Configuration
Configuration
If the touchscreen will connect to the wireless network, you must configure the Wi-Fi settings on the
device. Use Composer Pro to add the touchscreen driver to your project and configure the device
features.
Refer to the following for more information:
•
Configure for Wireless, page 15
•
Configure in Composer Pro, page 16
Configure for Wireless
(Wi-Fi only) Complete the following procedure to connect to a WAP using the touchscreen.
Procedure
Step 1
After initialization, press and hold the large White
4
in the center of the touchscreen to enter the
configuration screen.
Step 2
Press the
Network
button on the touchscreen’s configuration page. The network configuration screen
displays.
Step 3
Under Wireless, select
Enable
. If you don’t see the network you want, select
Other
.
Step 4
At Network Name, select to add the SSID or wireless network when the keyboard appears. Select
Done
.
Step 5
At Security, select
None
,
WEP 64
,
WEP 128
,
WPA
, or
WPA2
.
Step 6
At Password, type the password on the keyboard that appears. Press
Done
.
Step 7
Select
Connect
. Notice that the IP settings change. The IP address is set to DHCP by default.
Step 8
(Optional) If you need to set a static IP address instead, complete the following steps:
a.
On the Network page, press
Static
.
b.
Select each box one at a time and type the address: IP Address, Subnet Mask, Default Gateway,
Preferred DNS, and Alternate DNS.
c.
When the keyboard appears, type the address, and then press
Done
.
Step 9
Press
OK
to return to the Network page. You can now connect to a Director (Cisco Controller) on the
network.
Step 10
Press
OK
.
