Cisco RV180, Руководство администратора

Страница: 51 / 187

Configuring Networking
Configuring Routing
Cisco RV180/RV180W Administration Guide 42
2
The other routing mode, “router,” is used if your ISP has assigned you multiple IP
addresses so that you have an IP address for each endpoint on your network. You
must configure either static or dynamic routes if you use this type of routing.
See Configuring Static Routes, page 44 , or Configuring Dynamic Routing,
page 45 .
To choose your routing mode:
STEP 1
Select Networking > Routing > Routing Mode.
STEP 2
Click the box next to the type of routing to configure.
STEP 3
Click Save.
NOTE
If you have already configured DMZ or firewall settings on your router in gateway
(NAT) mode, selecting “router” changes those settings back to the default.
Viewing the Routing Table
To view routing information your network:
STEP 1
Choose Networking > Routing > Routing Table.
STEP 2
Next to the type of network you have, click Display.
Information about your network routing is displayed, including the following:
IPv4 Routing Table
• Destination—Destination host/network IP address for which this route is
added.
• Gateway—The gateway used for this route.
• Genmask—The netmask for the destination network.
• Metric—The distance to the target (usually counted in hops).
• Ref—Number of references to this route.
• Use—Count of lookups for the route. Depending on the use of -F and -C, this
is either route cache misses (-F) or hits (-C).
• Interface—Interface to which packets for this route will be sent.