Cisco Prisma II HD-LRMW, Инструкция по установке и эксплуатации

Страница: 43 / 128

Connecting the RF Cables to the Chassis
19
Connecting the RF Cables to the Chassis
To Connect RF Cables for Each Module
Complete the appropriate procedure below to connect RF cables for the
module.
Note: These procedures assume that the chassis is mounted in a rack.
Standard Prisma II Chassis
1
Attach a 75-ohm RF cable to the appropriate RF source.
2
At the front/rear of the chassis, locate the RF ports.
Note: RF ports are located on the front of the front access chassis.
3
Attach the other end of the RF cable to Port A connector (RF IN) of the
corresponding slot where the module is to be installed. This is the RF
input connection.
4
If F-connectors are installed, use a 7/16-in. open-end wrench to secure
both cables to the connectors at the chassis.