Cisco ONS 15454, Руководство по установке оборудования

Страница: 53 / 516

C H A P T E R
3
Installing the ONS 15454 M12 (ANSI and ETSI)
Shelf
This chapter explains how to install the ONS 15454 (ANSI and ETSI) shelf.
Unless otherwise specified, “ONS 15454” refers to both ANSI and ETSI M12 shelf assemblies. Note
Due to memory limitations, TCC2/TCC2P cards are not supported as the node controller in multi-shelf
configuration from R10.5.2.6. Hence, it is recommended to use TCC3 card as the node controller in multi-shelf
configuration. The TCC2P card can be used as a control card in a subtended shelf where the node controller
is TCC3 card on ONS 15454 chassis or TNC/TNCE/TNCS/TNCS-O cards on ONS 15454 M6 or NCS 20015
chassis. The TCC2P card can also be used as a node controller in a stand-alone configuration.
Note
• ONS 15454 ANSI Rack Installation, on page 24
• ONS 15454 ETSI Rack Installation , on page 27
• NTP-G306 Install the ONS 15454 Shelf, on page 31
• Front Door, on page 45
• ONS 15454 ANSI Backplane Covers, on page 53
• NTP-G3 Open and Remove the Front Door , on page 56
• NTP-G4 Open and Remove the FMEC Cover (ETSI Only), on page 60
• NTP-G5 Remove the Backplane Covers (ANSI Only), on page 63
• ONS 15454 ETSI Front Mount Electrical Connection, on page 65
• NTP-G6 Install the MIC-A/P and MIC-T/C/P FMECs (ETSI Only), on page 66
• Power and Ground Description, on page 67
• NTP-G7 Install the Power and Ground , on page 68
• Shelf Voltage and Temperature, on page 75
• NTP-G230 View Shelf Voltage and Temperature, on page 76
• Fan-Tray Assembly , on page 76
• NTP-G8 Install the Fan-Tray Assembly , on page 82
• ONS 15454 ANSI Alarm Expansion Panel, on page 85
• NTP-G9 Install the Alarm Expansion Panel (ANSI Only), on page 91
• ONS 15454 ANSI Alarm, Timing, LAN, and Craft Pin Connections, on page 94
Cisco ONS 15454 Hardware Installation Guide
23