Cisco ONS 15310-MA SDH, Руководство по процедурам

Страница: 483 / 632

17-77
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
78-19416-01
Chapter 17 DLPs H100 to H199
DLP-H185 Roll Two Cross-Connects on One Optical Circuit Using Automatic
Routing
Step 1
From the View menu, choose Go To Network View .
Step 2
Click the Circuits tab .
Step 3 Click the circuit that has the connections that you want to roll. The circuit must have a DISCOVERED
status for you to start a roll.
Step 4
From the Tools menu, choose Circuits > Roll Circuit .
Step 5 In the Roll Attributes area, complete the following ( Figure 17-6 ):
a.
From the Circuit Roll Mode drop-down list, choose Auto to create an automatic roll or Manual to
create a manual roll.
b.
From the Circuit Type drop-down list, choose Dual to indicate that you want to roll two connections
on the chosen circuit.
Figure 17-6 Selecting Dual Roll Attributes
Step 6
Click Next .
Step 7
In the Pivot/Fixed Point 1 window, click the square representing the fixed path of the first connection to
be rolled (
Figure 17-3 on page 17-73 ).
This path is a fixed point in the cross connection involved in the roll process. The path identifier appears
in the text box below the graphic image. The path that is not selected contains the Roll From path. The
Roll From path is deleted after the roll is completed.
Purpose This task reroutes the network path while maintaining the same source and
destination. This task allows CTC to automatically select a Roll To path.
Tools/Equipment None
Prerequisite Procedures DLP-H29 Log into CTC, page 16-43
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher