8
SCG1006
Cisco Nexus 5548UP Switch Configuration Guide
exit
telnet server enable
no ssh server enable
Would you like to edit the configuration? (yes/no) [n]:
n
Use this configuration and save it? (yes/no) [y]:
y
[########################################] 100%
Copy complete, now saving to disk (please wait)...
Log in with the credentials created in the previous steps.
2.4
Configure the vPC domain
switch#
configure
switch(config)#
feature lacp
switch(config)#
feature vpc
switch(config)#
vpc domain 1
switch(config-vpc-domain)#
peer-keepalive destination peer IP address
--------:: Management VRF will be used as the default VRF ::--------
Note: For the <
peer IP address> , use the management IP address of the partner switch.
switch(config-vpc-domain)#
exit
2.5
Enable link level flow control (802.3x)
You must perform this step for each individual port that is connected to a storage controller or a host
interface port, or you can specify a range of ports to configure.
switch(config)#
interface ethernet 1/1-32
switch(config-if-range)#
priority-flow-control mode off
switch(config-if-range)#
flowcontrol send on
switch(config-if-range)#
flowcontrol receive on
switch(config-if-range)#
exit
2.6
Configure Port Channel
switch(config)#
interface port channel 1
