S e n d f e e d b a c k t o n e x u s 4 K - d o c f e e d b a c k @ c i s c o . c o m
6
Cisco Nexus 4001I and 4005I Switch Module for IBM BladeCenter Getting Started Guide
OL-19952-02
Configuring the Switch
Figure 3
AMM I/O Module Configuration Window
Step 9
In the New Static IP Configuration area, enter the new IP address, the Subnet mask, and the Gateway
address. Click
Save
.
Note
The Save button is located in the lower, right portion of the window.
Step 10
Click the
Advanced Configuration
link. Take the following actions for switch module features:
a.
Enable external management for all ports.
b.
Preserve the new IP configuration on all resets.
Note
These features are disabled, by default.
Step 11
(Optional) To begin a Telnet session to the switch module, click the
Start Telnet Session
link. Click
Start Telnet
.
Step 12
Click
Save
to save your settings. Exit the AMM web interface.
Initial Setup
To enter the basic configuration parameters, perform the following steps:
Step 1
Open the AMM and configure the IP address, subnet mask, and gateway address for the management
interface (mgmt1), as described in
“Assigning the IP Address on the switch module” section on page 4
.
Step 2
Telnet to the mgmt1 IP address and log in using the following (default) user ID and password:
•
Login ID is
USERID
.
•
Password is
PASSW0RD
(the 0 in PASSW0RD is a zero).
You can now configure the switch module.
