![background image](http://html.mh-extra.com/html/cisco/meraki-z3/meraki-z3_installation-manual_64968007.webp)
• Choose
Web proxy > Yes
.
• Enter values as appropriate for
Hostname or IP
and
Port
.
• If you require authentication, choose
Authentication > Use authentication
, and enter appropriate values for
Username
and
Password
.
Configuring physical link settings
To configure physical link settings on the Ethernet ports, click
Local status > Ethernet configuration
. You can enable
half duplex, full duplex, and autonegotiation, as well as set 10- or 100-Mbps data rates.
Power efficiency modes
The Meraki Z3 Teleworker Appliance has an off mode and a networked standby or efficient idle mode, both with power
consumption less than 12W.
In off mode, the power consumption is a measured 0.3W. In the networked standby or efficient idle mode, the power
consumption is under that of full operation mode, which is a measured 6.6W. This mode is initiated after treating the last
payload packets.
To activate and/or deactivate wireless network ports, you may use the physical on/off switch or deactivate through the
Meraki Dashboard.
Regulatory
This equipment is for indoor use only and the PoE device is considered unlikely to connect to an Ethernet network with
outside plant routing, including campus environments.
FCC Compliance Statement
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device
may not cause harmful interference, and (2) this device must accept any interference received, including interference
that may cause undesired operation.
FCC Interference Statement
To apply all configuration settings to the gateway, be sure to click
Save Settings
at the bottom of the page.
7
Содержание Meraki Z3
Страница 4: ...The Z3 bottom panel 4 ...