Networking
Configuring Routing
Cisco ISA500 Series Integrated Security Appliances Administration Guide
150
4
Configuring Static Routing
Use the Networking > Routing > Static Routing page to configure static routes. You
can optionally assign a priority, which determines the route is selected when there
are multiple routes travelling to the same destination.
NOTE
Up to 150 static routing rules can be configured on the security appliance.
STEP 1
To add a static route, click
Add
. To edit an entry, click the
Edit
(pencil) icon.
Other options:
To delete an entry, click the
Delete
(x) icon. To delete multiple
entries, check them and click
Delete
.
STEP 2
Enter the following information:
•
Destination Address:
Choose an existing address object for the host or for
the network that the route leads to. If the address object that you want is not
in the list, choose
Create a new address
to create a new address object. To
maintain the address objects, go to the Networking > Address Management
page. See
•
Setting as default route:
Check this box to set this static route as the default
route.
•
Next Hop:
Choose a port or an IP address as the next hop for this static route.
-
Interface:
Choose either WAN1 or WAN2 as the next hop.
-
IP Address:
Choose an IP address of the gateway through which the
destination host or network can be reached.
•
Metric:
Optionally, enter a number to manage the route priority. If multiple
routes to the same destination exist, the route with the lowest metric is
selected.
STEP 3
Click
OK
to save your settings and close the pop-up window.
STEP 4
Click
Save
to apply your settings.
