8
LAN 3
9
LAN 4
10
VGA video port (DB-15)
Table 3 Rear Panel Ports (continued)
Figure 2 Front Panel Showing KVM Connector
1
KVM connector
Table 4 Front Panel Ports
Connect Using the Serial Port
1.
Connect the Ethernet LAN cable from the LAN 1 port on the rear of the unit to your network.
The LAN 1 port is the left-hand port of the dual port adapter on the rear panel of the unit (shown in
Figure 1
Rear Panel Showing Ports, page 10
).
2.
Connect a serial cable from the serial port on the rear of the unit to the serial port on a PC (see
Figure 1 Rear
Panel Showing Ports, page 10
).
The serial cable used must be a cross-over cable. The pin assignment for the serial cable is:
Male RJ45 pin
Female DB9 pin
1
8
2
6
3 TXD
2
4 GND
5
5 GND
5
6 RXD
3
7
4
8
7
Note:
If there is no DB9 port on your PC, a DB9 to USB serial port adapter is required.
11
Cisco Expressway CE1100 Appliance Installation Guide
Configure
