12
Cisco Edge 300 Series Switch Installation Guide
OL-24909-02
Installing the Switch
Step 6
Mark the locations on the wall for the mounting screws. Make sure that the holes are the proper distance
apart, depending on the switch orientation.
Note
If you are mounting the switch on a wooden wall (not drywall), you can screw the tapping screws
directly into the wall.
Step 7
Drill four 0.25-inch (6-mm) holes that are at least 1 inch (25 mm) deep.
Step 8
Insert the plastic drywall anchors into the holes.
Step 9
Insert a tapping screw into each anchor, and leave 0.06 inches (1.5 mm) of the screw head exposed.
Step 10
Place the bracket slots over the tapping screws, and slide the bracket down until the screws fit snugly
into the slots.
Install the Switch on a Desk or Table
Step 1
Use the two M3.0 x 6-mm Phillips pan head screws to attach the desktop bracket to the bottom of the
switch (see
Figure 9
).
Figure 9
Attaching the Desktop Bracket
1
M3.0 x 6mm Phillips pan head screws
255424
1