80
4011350 Rev D
How Do I Configure the Wireless Home Gateway?
Setup Advanced Settings - MAC Filtering Page Description
Use this page to enter the MAC address or MAC addresses of devices whose Internet
access you want to control. Click
Add MAC Address
to apply and save your new
MAC address filter settings.
Setting Up MAC Address Filters
The Block/Pass drop down menu allows you to block or pass Internet access to the
MAC addresses of the devices you list in the MAC Address Filters table. The
following table describes the function of the Block/Pass drop down menu.
Field Name
Description
Block Listed (Default)
Select
Block
to deny Internet access to the MAC addresses
of the devices you list in the table. All other MAC
addresses will be allowed Internet access.
Pass
Select
Pass
to allow Internet access only to the MAC
addresses of the devices you list in the table. Any MAC
addresses
not
listed in the table will be denied Internet
access.
Function Keys
Key
Description
Add MAC Address
Adds the MAC address you enter in the
Add MAC
Address
field
Remove MAC Address
Click to remove a selected MAC address from the list
Clear All
Click to remove all MAC addresses from the list
Configuring and Enabling TCP and UDP Port Filters
Use the Setup Advanced Settings - Port Filtering page to configure and enable TCP
and UDP port filters. These filters prevent a range of TCP/UDP ports from accessing
the Internet. You can also prevent PCs from sending outgoing TCP/UDP traffic to
the WAN on specific IP port numbers. This filter is not IP address- or MAC address-
specific. The system blocks the specified port ranges for all PCs.
Note:
If you are not familiar with the advanced settings detailed in this section,
contact your service provider before you attempt to change any of the wireless home
gateway default advanced port filtering settings.
Click
Port Filtering
in the Advanced Settings section of the Setup page to access the
Setup Advanced Settings - Port Filtering page.
