Configuring Firewall
Configuring Access Control
Cisco CVR100W Wireless-N VPN Router Administration Guide
93
5
•
Telnet SSL
•
Voice (SIP)
(Optional) Click
Configure Services
to go to the Service Management page to
configure the services before applying access rules to them.
STEP 7
In the
Source IP
field, select the users to which the access rule applies:
•
Any:
The rule applies to traffic originating on any host in the local network.
•
Single Address:
The rule applies to traffic originating on a single IP address
in the local network. Enter the address in the
Start IP
field.
•
Address Range:
The rule applies to traffic originating from an IP address
located in a range of addresses. Enter the starting IP address in the
Start IP
field, and the ending IP address in the
Finish
field.
STEP 8
In the
Destination IP
field, select the users to which the access rule applies:
•
Any:
The rule applies to traffic originating on any host in the local network.
•
Single Address
: The rule applies to traffic originating on a single IP address
in the local network. Enter the address in the
Start IP
field.
•
Address Range:
The rule applies to traffic originating from an IP address
located in a range of addresses. Enter the starting IP address in the
Start IP
field, and the ending IP address in the
Finish
field.
STEP 9
In the
Log
field, specify whether the packets for this rule should be logged.
To log details for all packets that match this rule, choose
Always
from the drop-
down menu. For example, if an outbound rule for a schedule is selected as
Always
block
, for every packet that tries to make an outbound connection for that service,
a message with the packet's source address and destination address (and other
information) is recorded in the log.
Enabling logging may generate a significant volume of log messages and is
recommended for debugging purposes only.
Choose
Never
to disable logging.
STEP 10
In the
QoS
Priority
field, assign a priority to IP packets of this service.
The priorities are defined by QoS Level: (
1 (lowest)
,
2
,
3
,
4 (highest)
).
STEP 11
In the
Rule Status
field, check to enable the new access rule.
STEP 12
Click
Save
.