C H A P T E R
3
Power Supply Installation
•
Power Supply Installation, on page 37
•
Power Supply Modules, on page 37
•
Power Supply Installation Guidelines, on page 38
•
Installing a Power-Supply Module, on page 39
•
Remove the Power-Supply Module, on page 46
Power Supply Installation
This chapter describes how to remove and install a new or replacement power supply. Your switch ships with
at least one power-supply module (AC or DC, depending on your order).
The power-supply modules are field-replaceable units (FRUs) and are hot-swappable when deployed in
nonhazardous locations.
For translations of the safety warnings in this chapter, see the
Regulatory Compliance and Safety Information
for the Cisco IE9300 Rugged Series Switches
on Cisco.com.
Power Supply Modules
This section contains information about the power supply modules compatible with the switch.
All the power supply modules in the following table are compliant for hazardous environments.
Table 14: Power Supply Modules
Description
Model
Low voltage DC. For detailed specifications, see the Cisco Catalyst
IE9300 Rugged Series Switch data sheet.
PWR-RGD-LOW-DC-H
AC and high-voltage DC. For detailed specifications, see the Cisco
Catalyst IE9300 Rugged Series Switch data sheet.
PWR-RGD-AC-DC-H
AC and high-voltage DC. For detailed specifications, see the Cisco
Catalyst IE9300 Rugged Series Switch data sheet.
PWR-RGD-AC-DC-250
Cisco Catalyst IE9300 Rugged Series Switch Hardware Installation Guide
37
