Cisco Catalyst 6816-X-LE, Руководство по установке оборудования

Страница: 91 / 100

A P P E N D I X
D
Troubleshooting
Problems with the initial startup are often caused by a switching module that has become dislodged from the
backplane or a power supply that has been disconnected from the power cord connector. Although temperature
conditions above the maximum acceptable level rarely occur at initial startup, you might encounter these
conditions during extended operation. Long-term monitoring functions also include independent reporting of
DC-output voltage problems.
• Getting Started, on page 79
• Solving Problems at the System Component Level, on page 79
• Identifying Startup Problems, on page 80
• Troubleshooting the Power Supply, on page 80
• Troubleshooting the Fan Tray , on page 81
• Status LED Indicators, on page 82
• Contacting Cisco Customer Service, on page 82
• Finding the Serial Number, on page 83
Getting Started
When the initial system startup is complete, verify the following:
• Power supplies are supplying power to the system.
• The fan tray assembly is operating.
• System software boots successfully.
If one or more of the above conditions are not met, use the procedures described in this chapter to isolate and,
if possible, resolve the problem. If all of the above conditions are met, and the hardware installation is complete,
refer to your software release notes for hardware support information and software caveats.
Solving Problems at the System Component Level
The key to success when troubleshooting the system is to isolate the problem to a specific system component.
The first step is to compare what the system
is doing to what it should be doing . Because a startup problem
can usually be attributed to a single component, it is more efficient to isolate the problem to a subsystem rather
than troubleshoot each separate component in the system.
Catalyst 6840-X Switch Series Hardware Installation Guide
79