Cisco Catalyst 4500 Series, Руководство по настройке программного обеспечения

Страница: 1481 / 2086

55-19
Catalyst 4500 Series Switch, Cisco IOS Software Configuration Guide - Cisco IOS XE 3.9.xE and IOS 15.2(5)Ex
Chapter 55 Configuring Port Security
Configuring Port Security on Trunk Ports
Examples of Trunk Port Security
The following examples are provided:
•
Example 1: Configuring a Maximum Limit of Secure MAC Addresses for All VLANs, page 55-19
•
Example 2: Configuring a Maximum Limit of Secure MAC Addresses for Specific VLANs,
page 55-20
•
Example 3: Configuring Secure MAC Addresses in a VLAN Range, page 55-20
Example 1: Configuring a Maximum Limit of Secure MAC Addresses for All VLANs
This example shows how to configure a secure MAC-address and a maximum limit of secure MAC
addresses on Gigabit Ethernet interface 1/1 for all VLANs:
Switch# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Switch(config)#
interface g1/1
Switch(config-if)# switchport trunk encapsulation dot1q
Switch(config-if)# sw mode trunk
Switch(config-if)#
switchport port-security
Switch(config-if)# switchport port-security maximum 3
Switch#
show port-security in gi1/1 vlan
Default maximum: 3
VLAN Maximum Current
1 3 0
2 3 0
3 3 0
4 3 0
Step 4
Switch(config-if)# switchport port-security
maximum value vlan
Configures a maximum number of secure mac-addresses
for each VLAN on the interface that are not explicitly
configured with a maximum mac-address limit. See the
“Maximum Number of Secure MAC Addresses” section
on page 55-4
.
Step 5
Switch(config-if)# vlan-range range Enters VLAN range sub-mode.
Note
You can specify single or multiple VLANs.
Step 6
Switch(config-if-vlan-range)#
port-security maximum value
Configures a maximum number of secure MAC addresses
for each VLAN.
Step 7
Switch(config-if-vlan-range)#
no port-security maximum
Removes a maximum number of secure MAC addresses
configuration for all the VLANs. Subsequently, the
maximum value configured on the port will be used for all
the VLANs.
Step 8
Switch(config-if-vlan-range)# [ no ] port-security
mac-address mac_address
Configures a secure MAC-address on a range of VLANs.
Step 9
Switch(config-if-vlan-range)# [ no ] port-security
mac-address sticky mac_address
Configures a sticky MAC-address on a range of VLANs.
Step 10
Switch(config-if-vlan-range)# end
Returns to interface configuration mode.
Step 11
Switch(config-if)# end
Returns to privileged EXEC mode.
Command Purpose