Cisco Catalyst 4500 E Series Supervisor Engine 9-E, Инструкция по установке и настройке

Страница: 2 / 21

Revised: January 4, 2018,
Installation and Configuration Note for Cisco Catalyst 4500
E-Series Supervisor Engine 9-E
Product Numbers: WS-X45-SUP9-E , WS-X45-SUP9-E= (Spare), WS-X45-SUP9-E/2 (Redundant Supervisor)
This document describes the features of the Cisco Catalyst 4500 E-Series Supervisor Engine 9-E and provides information about
how to correctly install and remove or replace the module.
Table 1: WS-X45-SUP9-E Chassis Compatibility Information
Description Compatibility Information
Cisco Catalyst 4500 E-Series Supervisor Engine 9-E is supported on the Catalyst
4503-E, Catalyst 4506-E, and Catalyst 4507R+E, Catalyst 4510R+E switch
chassis. Chassis compatibility
Cisco IOS XE Release 3.10.0E and ROMMON IOS Version 15.1(1r)SG14.
For the latest software release requirements, refer to the Cisco IOS Release Notes
for the Catalyst 4500-E Series Switches at this location: http://www.cisco.com/
c/en/us/support/switches/catalyst-4500-series-switches/
products-release-notes-list.html
.
Minimum software requirements
•
Catalyst 4503-E
—
Slot 1 only
• Catalyst 4506-E — Slot 1 only
• Catalyst 4507R+E — Slot 3 and slot 4 (redundant supervisor engines
supported)
•
Catalyst 4510R+E
—
Slot 5 and slot 6 (redundant supervisor engines
supported)
Chassis slot restrictions
48 Gbps per slot — on all supported chassis. Bandwidth per slot
Safety Warnings
Safety warnings appear throughout this publication in procedures that may harm you if you perform them incorrectly. A warning
symbol precedes each warning statement. The warnings below are general warnings that are applicable to the entire publication.
2