Cisco Catalyst 3560, Руководство по установке оборудования

Страница: 128 / 168

Appendix C Configuring the Switch with the CLI-Based Setup Program
Entering the Initial Configuration Information
C-10
Catalyst 3560 Switch Hardware Installation Guide
78-16057-01
Step 10
These choices are displayed:
[0] Go to the IOS command prompt without saving this config.
[1] Return back to the setup without saving this config.
[2] Save this configuration to nvram and exit.
If you want to save the configuration and use it the next time the switch reboots,
save it in NVRAM by selecting option 2.
Enter your selection [2]: 2
Make your selection, and press Return .
After you complete the setup program, the switch can run the default
configuration that you created. If you want to change this configuration or want
to perform other management tasks, use one of these tools:
•
Command-line interface (CLI)
•
CMS from your browser
To use the CLI, enter commands at the Switch > prompt through the console port
by using a terminal program or through the network by using Telnet. For
configuration information, refer to the switch software configuration guide or the
switch command reference.
To use CMS, refer to the software configuration guide.