Cisco Catalyst 3560-X Series, Руководство по настройке программного обеспечения

Страница: 149 / 1538

1-17
Catalyst 3750-X and 3560-X Switch Software Configuration Guide
OL-25303-03
Chapter 1 Managing Switch Stacks
Understanding Switch Stacks
•
“Private VLANs and Switch Stacks” section on page 1-5
• “Spanning Tree and Switch Stacks” section on page 1-12
•
“MSTP and Switch Stacks” section on page 1-8
• “DHCP Snooping and Switch Stacks” section on page 1-7
•
“IGMP Snooping and Switch Stacks” section on page 1-7
• “Port Security and Switch Stacks” section on page 1-18
•
“CDP and Switch Stacks” section on page 1-2
• “SPAN and RSPAN and Switch Stacks” section on page 1-10
•
“ACLs and Switch Stacks” section on page 1-7
• “EtherChannel and Switch Stacks” section on page 1-10
•
“IP Routing and Switch Stacks” section on page 1-3
• “IPv6 and Switch Stacks” section on page 1-15
•
“HSRP and Switch Stacks” section on page 1-5
• “Multicast Routing and Switch Stacks” section on page 1-10
•
“Fallback Bridging and Switch Stacks” section on page 1-3
Switch Stack Management Connectivity
You manage the switch stack and the stack member interfaces through the stack master. You can use the
CLI, SNMP, Network Assistant, and CiscoWorks network management applications. You cannot manage
stack members on an individual switch basis.
These sections provide switch stack connectivity information:
• Connectivity to the Switch Stack Through an IP Address, page 1-17
•
Connectivity to the Switch Stack Through an SSH Session, page 1-18
• Connectivity to the Switch Stack Through Console Ports or Ethernet Management Ports, page 1-18
•
Connectivity to Specific Stack Members, page 1-18
Connectivity to the Switch Stack Through an IP Address
The switch stack is managed through a single IP address. The IP address is a system-level setting and is
not specific to the stack master or to any other stack member. You can still manage the stack through the
same IP address even if you remove the stack master or any other stack member from the stack, provided
there is IP connectivity.
Note Stack members retain their IP addresses when you remove them from a switch stack. To avoid a conflict
by having two devices with the same IP address in your network, change the IP addresses of any switches
that you remove from the switch stack.
For related information about switch stack configurations, see the “Switch Stack Configuration Files”
section on page 1-16 .