2-27
Catalyst 3750-X and 3560-X Switch Hardware Installation Guide
OL-19593-01
Chapter 2 Switch Installation
Connecting Devices to the Ethernet Ports
Figure 2-27
Network Module with SFP Modules Installed
Removing an SFP Module
Step 1
Attach an ESD-preventive wrist strap to your wrist and to a bare metal surface.
Step 2
Disconnect the cable from the SFP module. For reattachment, note which cable connector plug is send
(TX) and which is receive (RX).
Step 3
Insert a dust plug into the optical ports of the SFP module to keep the optical interfaces clean.
Step 4
If the module has a bale-clasp latch, pull the bale out and down to eject the module. If the bale-clasp
latch is obstructed and you cannot use your finger to open it, use a small, flat-blade screwdriver or other
long, narrow instrument to open the bale-clasp latch.
Step 5
Grasp the SFP module, and carefully remove it from the module slot.
Step 6
Place the removed SFP module in an antistatic bag or other protective environment.
Connecting Devices to the Ethernet Ports
•
10/100/1000 Ethernet Port Connections, page 2-28
•
PoE+ Port Connections, page 2-28
Caution
Category 5e and Category 6 cables can store high levels of static electricity. Always ground the cables
to a suitable and safe earth ground before connecting them to the switch or other devices.
1
Network module
3
Send (TX) optical bore
2
SFP modules
4
Receive (RX) optical bore
Cataly
s
t
3
750-X P
oE+4
8
3
7
38
3
9
40
41
42
4
3
44
45
46
47
4
8
C
3
KX-NM-10G
NETW
ORK
MODULE
G1
G2/TE1
G
3
G4/TE2
253157
1
3
4
2
Содержание Catalyst 3560-X Series
Страница 7: ...Contents vii Catalyst 3750 X and 3560 X Switch Hardware Installation Guide OL 19593 01 I N D E X ...
Страница 8: ...Contents viii Catalyst 3750 X and 3560 X Switch Hardware Installation Guide OL 19593 01 ...
Страница 114: ...Index IN 6 Catalyst 3750 X and 3560 X Switch Hardware Installation Guide OL 19593 01 ...