2
1
Introduction
This guide provides instructions on how to install your Cisco Catalyst Blade Switch 3040 for
FSC—referred to as the
blade switch
—in the Fujitsu Siemens PRIMERGY BX600 S2 system and to set
up and configure it. The PRIMERGY BX600 S2—referred to as the
BX600 system
—supports up to
four Ethernet blade switches in its blade bays.
This guide also covers management options and troubleshooting help for the blade switch.
For details on the numbers, types, and the location of the BX600 system slots, for additional
information on the BX600 system, and for detailed port mapping information, see the BX600 setup
and installation guide at
http://manuals.fujitsu-siemens.com/primergyservers.html
.
For additional installation and configuration information about the blade switch, see the Cisco
Catalyst Blade Switch 3040 for FSC documentation on Cisco.com. For system requirements, important
notes, limitations, open and resolved caveats, and last-minute documentation updates, see the release
notes, also on Cisco.com.
When using the online publications, refer to the documents that match the Cisco IOS software version
that is running on the blade switch. See the “Obtaining Documentation” section on page 1-24 for more
information about the related publications.
For translations of the warnings that appear in this publication and all safety and handling warnings
for this product, see the
Regulatory Compliance and Safety Information for the Cisco Catalyst Blade
Switch 3040 for FSC
that accompanies this guide.
Before proceeding, read the release notes for the BX600 system. The release notes are available on the
FSC support website at
http://support.fujitsu-siemens.com/com/support/index.html
.
2
Taking Out What You Need
These items ship with your blade switch:
•
Console cable
•
Cisco Catalyst Blade Switch 3040 for FSC Getting Started Guide
(this book)
•
Regulatory Compliance and Safety Information for the Cisco Catalyst Blade Switch 3040 for FSC
•
Registration card
Follow these steps:
1.
Unpack and remove the blade switch and the accessory kit from the shipping box.
2.
Return the packing material to the shipping container, and save it for future use.
If you ordered the blade switches with the BX600 system, they are already installed. The unpacking
procedure only applies if a blade switch is ordered separately. See the BX600 system documentation
for the unpacking procedure for the BX600 system equipment.
3040GSG.fm Page 2 Monday, September 18, 2006 9:45 AM
