Cisco Catalyst 3000, Руководство администратора

Страница: 43 / 496

with a particular station within the system. In the case of the All Call Types option, customers are responsible
for determining how calls on a trunk are routed (for example: attendant number or directory number).
In the case of Emergency Calls Only, a call-back pattern is set up that ensures that incoming calls are routed
to the last number that called out on that particular gateway.
If an ELIN is associated with an analog trunk, Cisco recommends that it be configured on that analog trunk.
If the ELIN is using a digital gateway (example: T1 or PRI connection), Cisco recommends that it be configured
on the site.
To confirm that the configuration for emergency calling is successful, after the SPA8800 is configured, go to
the site page and confirm that the DID for that trunk is listed as an ELIN. If it is not listed as an ELIN, check
the other sites to see if it appears on one of them, it may have been set up on the wrong site. If this happens,
check the IP address and subnet settings in Cisco Business Edition 3000 to ensure that the gateway is registering
at the correct site.
The manner in which a particular SPA8800 is associated with a site is based on the IP address and the
subnets that have been set up for that site. Note
PSTN Connection Settings
For information about how to edit the SPA8800 connections, see Connection Type: FXO, on page 294 .
Perform the Initial Setup on the SPA8800 for IP Addresses using SPA Interactive Voice Response
The SPA8800 requires setup through the SPA Interactive Voice Response (IVR) menu to locate the Cisco
Business Edition 3000.
Use the following procedure to perform this setup.
Procedure
Step 1 Connect an analog phone to port 1.
Step 2 Go off hook and enter the configuration menu by pressing the * (star) key four times.
Step 3 Enter
101
followed by the
#
(pound) key to set the Internet connection type, followed by
1#
to set it to static
IP addressing.
Step 4 Enter 111# to set the static IP address.
DHCP must be set to Disabled; otherwise you
hear
Invalid option
if you try to set this value. A password is
required. Note
Step 5 Enter IP address using numbers on the telephone key pad. Use the
*
(star) key to enter a decimal point, followed
by the
#
(pound) key. Press
1
to save the configuration change.
If, while entering a value (for example, an IP address), you decide to exit without saving any changes, you
must press the
*
(star) key twice within a half-second window of time. Otherwise, the entry of the
*
(star) key
will be treated as a dot (decimal point).
To enter IP address, use numbers 0 - 9 on the telephone key pad and use the * (star) key to enter a
decimal point.
Tip
Administration Guide for Cisco Business Edition 3000, Release 8.6(4)
OL-27022-01 23
Components of the Cisco Business Edition 3000 System