Cisco C390, Быстрый старт

Страница: 5 / 16

5
Install the Appliance in a Rack
Install the Cisco C390 Email Security Appliance using the rails supplied. For
information about installing the appliance in a rack, see the
Cisco x90 Series
Content Security Appliances Installation and Maintenance Guide .
Appliance Placement in a Rack
•
Ambient Temperature—To prevent the appliance from overheating, do not
operate it in an area that exceeds an ambient temperature of 104°F (40°C).
•
Air Flow—Be sure that there is adequate air flow around the appliance.
•
Mechanical Loading—Be sure that the appliance is level and stable to avoid
any hazardous conditions.
Plug In the Appliance
Plug the female end of each straight power cable into the redundant power
supplies on the back panel of the appliance.
Plug the male end(s) into an electrical outlet.
Temporarily Change Your IP Address for Remotes
Access
To remotely configure the Cisco C390 using the network connection, you must
temporarily change the IP address of your computer. Alternatively, you can use
the serial console to configure the Cisco C390, without changing the IP address.
If you use the serial console, proceed to section 8 below.
Note
Make a note of your current IP configuration settings because you will
need to revert to these settings after you finish the configuration.