Cisco c240, Инструкция по установке и обслуживанию

Страница: 102 / 162

3-60
Cisco UCS C240 M4 Server Installation and Service Guide
OL-32474-01
Chapter 3 Maintaining the Server
Installing or Replacing Server Components
d.
Return the securing plate to the riser. Insert the two hinge-tabs into the two slots on the riser, and
then swing the securing plate closed.
e. Tighten the single thumbscrew that holds the securing plate.
Step 16
Install the PCIe riser with GPU card back into the server:
a. Position the PCIe riser over its socket on the motherboard and over its alignment features in the
chassis (see
Figure 3-24 ).
b.
Carefully push down on both ends of the PCIe riser to fully engage its circuit board connector with
the socket on the motherboard.
Step 17 Insert the front support bracket that you installed to the card in Step 13 into the latch that is on the air
baffle base that you installed in Step 12 .
a.
Pinch the latch release tab (see Figure 3-30 ) and hinge the latch toward the front of the server.
b. Hinge the latch back down so that its lip closes over the front edge of the support bracket that is
attached to the GPU card (see
Figure 3-30 ).
c.
Ensure that the latch release tab clicks and locks the latch in place.
Figure 3-30 GPU Front Support Bracket Inserted to Air Baffle Latch
1 Front end of GPU 3 Lip on support bracket latch
2 Front support bracket attached to GPU 4 Latch release tab
305088
1
2
3
4