9
Caution
If you are using a two-post rack, secure the rack to the floor surface to prevent tipping and avoid bodily injury and
component damage.
Step 1
Position the chassis so the front is closest to you and lift it carefully into the rack. To prevent injury, avoid any sudden
twists or moves.
Step 2
Slide the chassis into the rack, pushing it back until the rack-mount brackets meet the mounting strips or posts on both
sides of the rack.
Step 3
Position the chassis until the rack-mounting ears are flush against the mounting rails on the rack.
Note
To allow space to attach the cable-management brackets to the chassis in the rack easily, make certain that you use
the rack-mount bracket ear holes specified in Step 4.
Step 4
Hold the chassis in position against the mounting rails and follow these steps:
a.
Insert the bottom screw into the third hole up from the bottom of the rack mount ear and use a hand-held screwdriver
to tighten the screw to the rack rail.
b.
Insert the top screw into the third hole down from the top of the rack-mount bracket ear and tighten the screw to the
rack rail.
c.
Insert a screw in the middle of the rack-mount bracket on both sides of the chassis. See
Figure 4
.
Step 5
Repeat these steps for the other side of the chassis.
Note
As a result of using the specified rack-mount bracket ear holes, the cable-management bracket can be easily
attached to the rack-mount bracket when the chassis is in the rack.
This completes the procedure for installing the chassis in a two-post rack. Proceed to the
“Attach the Cable-Management
Bracket” section on page 9
to continue the installation.
Attach the Cable-Management Bracket
The cable-management brackets mount to each rack-mount bracket on the chassis to provide cable-management to both sides
of the chassis (parallel with card orientation). These brackets are screw mounted to the rack-mount brackets to allow easy
installation and removal of cables.
The cable-management brackets for the Cisco ASR 1006 Router contain 5 independent cable-management “U” type features
with four screws and provides cable dressing of each card module slots. For Cisco ASR 1000 SIPs, these brackets work in tandem
with shared port adapter product feature cable-management device to allow installation and removal of adjacent cards without
the need to remove cables.
Note
Make certain that the cable-management bracket “U” type feature is facing upwards when you attach it to the chassis
as shown in
Figure 6
.
Follow these steps to attach the cable-management brackets to both sides of the Cisco ASR 1006 Router in the rack:
Step 1
Align the cable-management bracket to the rack-mount bracket on one side of the Cisco ASR 1006 Router. The
cable-management bracket aligns to the top hole of the chassis rack-mount bracket.
1
Front rack-mount bracket ear hole location
2
Two-post rack equipment
Содержание ASR1006 - ASR 1006 Modular Expansion Base
Страница 45: ...45 ...