Cisco Aironet 1520 Series, Руководство по установке оборудования, Страница: 43 / 66

2-27
Cisco Aironet 1520 Series Outdoor Mesh Access Point Hardware Installation Guide
OL-12632-02
Chapter 2 Mounting Instructions
Mounting the Access Point
Step 4
Position the pole clamp bracket on the pole as needed before tightening the metal bands.
Note
When the metal bands are tightened to the full tension, the pole clamp bracket cannot be adjusted
unless the metal bands are cut or disassembled.
Step 5
Tighten the metal bands using the band strap tool (Cisco AIR-BAND-IT-TOOL=), following the
operating instructions in the box with the tool. Ensure the metal bands are as tight as possible.
Step 6 Place the mounting bracket onto the pole clamp bracket support bolt (see Figure 2-13 ).
Step 7
For vertical poles, position the mounting bracket as shown in Figure 2-13 . For horizontal streetlight
poles, rotate the mounting bracket 90
o
from the position shown in Figure 2-13 .
Step 8 Install four M8 x16 bolts (with flat and lock washers) into the bolt holes.
Figure 2-13 Screw Hole Locations on the Mounting Bracket and Pole Clamp Bracket Assembly
Step 9
Hand-tighten the bolts and the nut (do not overtighten).
Step 10 Adjust the top edge of the mounting bracket until it is horizontal and tighten the bolts and the flange nut
(see
Figure 2-13 ) to 13 to 15 ft lbs (17.6 to 20.3 Nm).
Note The mounting bracket can be adjusted up to 45
o
to compensate for tilted horizontal streetlight
poles.
1
Pole clamp bracket assembly
3
Bolt holes
2 Access point support bolt
(M8 flange nut not shown)
4 Mounting bracket