Cisco AIR-AP1121G-E-K9, Руководство по установке оборудования

Страница: 87 / 122

8-5
Cisco Aironet 1100 Series Access Point Hardware Installation Guide
OL-4309-02
Chapter 8 Troubleshooting
Resetting to the Default Configuration
Using the MODE Button
Follow these steps to delete the current configuration and return all access point settings to the factory
defaults using the MODE button:
Step 1 Disconnect power (the power jack for external power or the Ethernet cable for in-line power) from the
access point.
Step 2
Press and hold the MODE button while you reconnect power to the access point.
Step 3 Hold the MODE button until the Status LED turns amber (approximately 2 to 3 seconds), and release the
button.
Step 4
After the access point reboots, you must reconfigure the access point by using the Web browser
interface, the Telnet interface, or IOS commands.
Note
The access point is configured with the factory default values including the IP address (set to
receive an IP address using DHCP).
Using the Web Browser Interface
Follow the steps below to delete the current configuration and return all access point settings to the
factory defaults using the web browser interface.
Step 1
Open your Internet browser. You must use Microsoft Internet Explorer (version 5.x or later) or Netscape
Navigator (version 4.x).
Step 2 Enter the access point’s IP address in the browser address line and press Enter. An Enter Network
Password screen appears.
Step 3
Enter your username in the User Name field.
Step 4 Enter the access point password in the Password field and press Enter. The Summary Status page
appears.
Step 5
Click System Software and the System Software screen appears.
Step 6 Click System Configuration and the System Configuration screen appears.
Step 7
Click the Default button.
Note
If the access point is configured with a static IP address, the IP address does not change.
Step 8
After the access point reboots, you must reconfigure the access point by using the Web browser interface,
the Telnet interface, or IOS commands.