© Copyright 2011 Cisco Systems, Inc.
This document may be freely reproduced and distributed whole and intact including this Copyright Notice.
8
PWR MGMT
Orange
Power-up mode; running self-diagnostics.
Green
Power management is functioning normally and
sufficient power is available for all modules.
Orange
A minor power management problem has been
detected. There is insufficient power for all
modules to power up.
Red
A major power failure has occurred.
DISK 0 and
DISK 1
N/A
These LEDs are illuminated green when the
installed Flash PC card is being accessed and is
performing either a read operation or a write
operation.
Table 2 – LED Indicators
The module provides a number of physical and logical interfaces to the device, and the physical
interfaces provided by the module are mapped to the following FIPS 140-2 defined logical
interfaces: data input, data output, control input, status output, and power. The logical interfaces
and their mapping are described in the following table:
Router Physical Interface
FIPS 140-2 Logical Interface
Gigabit/SFP Ethernet ports
Console Port
Data Input Interface
Gigabit/SFP Ethernet ports
Console Port
Data Output Interface
Gigabit/SFP Ethernet ports
Console Port
Control Input Interface
Gigabit/SFP Ethernet ports
Console Port
LEDs
Status Output Interface
Power plug
Power Interface
Table 3 – FIPS 140-2 Logical Interfaces
2.3
Roles and Services
Authentication in the module is identity-based. There are two main roles in the router that
operators can assume:
1.
the Crypto Officer role and
2.
the User role.
The administrators of the router assumes the Crypto Officer role in order to configure and
maintain the router using Crypto Officer services, while the Users exercise only the basic User
services. A detailed list of services attributed to each role can be found in section 2.3.2
