72
Regulatory Compliance and Safety Information for Cisco 7200 Series Routers
78-3419-19
Site Preparation and Safety Information
•
For DC power supplies, locate the circuit breaker on the panel board that services the DC circuit,
switch the circuit breaker to the off position, and tape the switch handle of the circuit breaker in the
off position.
•
Do not touch the power supply when the power cord is connected. Line voltages are present within
the power supply even when the power switch is off and the power cord is connected.
Working with WAN Interfaces
•
Use caution when installing or modifying telephone lines to prevent electric shock.
•
Do not work on the system or connect or disconnect cables during periods of lightning activity.
•
Do not touch uninsulated telephone wires or terminals unless the telephone line has been
disconnected at the network interface.
•
Hazardous network voltages are present in WAN ports regardless of whether power to the system is
off or on. When detaching cables, detach the end away from the system first.
•
Do not use a telephone (unless it is the cordless type) during an electrical storm.
•
Do not use a telephone to report a gas leak in the vicinity of the leak.
•
Do not install telephone jacks in wet locations unless the jack is specifically designed for wet
locations.
Working with Lasers
•
Fiber-optic ports (for example, FDDI, OC-3, OC-12, OC-48, ATM, GBIC, and 100BaseFX) are
considered Class 1 laser or Class 1 LED ports.
•
These products have been tested and found to comply with Class 1 limits of IEC 60825-1, IEC
60825-2, EN 60825-1, EN 60825-2, and 21CFR1040.
•
To avoid exposure to radiation, do not stare into the aperture of a fiber-optic port. Invisible radiation
might be emitted from the aperture of the port when no fiber cable is connected.
Figure 3
,
Figure 4
, and
Figure 5
show examples of Class 1 laser and LED labels. The smaller labels
shown in Figure 3and Figure 4 usually appear on field-replaceable cards. Or the larger label shown in
Figure 5 appears on the chassis.
Figure 3
Class 1 Laser Label for a Single-Mode Fiber Port
Figure 4
Class 1 LED Label for a Multimode Fiber Port
11772
CLASS 1 LASER PRODUCT
LASERPRODUKT DER KLASSE 1
PRODUIT LASER DE CLASSE 1
PRODUCTO LASER CLASE 1
11773
CLASS 1 LED PRODUCT
PRODUKT MIT KLASSE 1 LED
PRODUIT AVEC VOYANT DEL
DE CLASSE 1
PRODUCTO LED DE LA CLASE 1
LED
