1-3
Cisco Video Surveillance 6050 IP Camera Installation Guide
OL-31413-01
Chapter 1 Overview
M12 Connector Pinouts
M12 Connector Pinouts
Figure 1-2
and the table that follows describe the pinouts of the M12 connector. You will need this
information if you use the waterproof connector when you install the IP camera.
Figure 1-2
M12 Connector Pinouts
1
Recessed Reset button.
This button reboots the IP camera or resets it to a default state. You can use a pin or paper clip to
depress it. It can be used any time that the IP camera is on and can have various effects, as
described in the
“Resetting the IP Camera” section on page 4-7
.
2
Status LEDs.
The power LED glows red when the IP camera is powered on. The Network LED blinks green
when the IP camera is connected to a network.
3
Lens.
4
Screw holes.
5
SD/SDHC card slot.
Pin
Description
1
TX+
2
TX–
3
RX+
4
RX–
5
V+
6
V+
