Cisco 3560V2 - Catalyst 48 10/100 Poe, Техническое описание

Страница: 12 / 20

Data Sheet
© 2009 Cisco Systems, Inc. All rights reserved. This document is Cisco Public Information. Page 12 of 20
availability of your network. LMS supports over 400 different device types, including Cisco Catalyst 3560 v2 series
switches, and it provides the following features:
●
Network discovery, topology views, end-station tracking, and VLAN management
●
Real-time network fault analysis with easy-to-deploy device specific best-practice templates
●
Hardware and software inventory management, centralized configuration tools, and syslog monitoring
●
Network response time and availability monitoring and tracking
●
Real-time device, link, and port traffic management, analysis, and reporting
●
For further details about CiscoWorks LMS, go to www.cisco.com/go/lms.
Table 2 describes switch hardware, Table 3 describes power specifications, Table 4 describes management and
standards support, and Table 5 describes safety and compliance.
Table 2. Cisco Catalyst 3560 v2 Series Switch Hardware
Description Specification
Forwarding bandwidth 32 Gbps
Flash memory 32 MB
Max VLANs 1K
VLAN IDs 4K
Switched Virtual Interfaces (SVIs) Up to 1000
Maximum transmission unit (MTU) Up to 9000 bytes
Jumbo frames 9016 bytes
MAC, routing, security, and QoS scalability numbers depend on the type of template used in the switch.
Default Template Access Template VLAN Template Routing Template
MAC address 6K 4K 12K 3K
IGMP groups and
multicast routes 1K 1K 1K 1K
Total unicast routes 8K 6K 0 11K
Directly connected
hosts 6K 4K 0 3K
Indirect routes 2K 2K 0 8K
Security ACEs 1K 2K 1K 1K
QoS ACEs 0.5K 0.5K 0.5K 0.5K
Performance
PBR ACEs 0 0.5K 0 0.5K
Connectors and Cabling ●
10BASE-T ports: RJ-45 connectors, two-pair Category 3, 4, or 5 unshielded twisted-pair (UTP) cabling
●
10BASE-T PoE ports: RJ-45 connectors, two-pair Category 3, 4, or 5 UTP cabling power pins 1,2 (negative) and
3,6 (positive)
●
100BASE-TX ports: RJ-45 connectors, two-pair Category 5 UTP cabling
●
100BASE-TX PoE ports: RJ-45 connectors, two-pair Category 5 UTP cabling, power on pins 1,2 (negative) and 3,6
(positive)
●
1000BASE-T SFP-based ports: RJ-45 connectors, four-pair Category 5 UTP cabling
●
1000BASE-SX, -LX/LH, -ZX, and CWDM SFP-based ports: LC fiber connectors (single/multimode fiber)
●
Cisco Catalyst 3560 SFP Interconnect Cable: two-pair shielded cabling, 50 cm
●
Management console port: RJ-45-to-DB-9 cable for PC connections; for terminal connections, use RJ-45-to-DB-25
female data-terminal-equipment (DTE) adaptor (can be ordered separately from Cisco; part number ACS-
DSBUASYN=)