VCC-5CL5M/R
Rev.905-0073-01
©2017 CIS Corporation. All rights reserved.
6
3.2.
Part Names and Functions
③
④
⑤
⑥ ⑦
①
②
①
. Lens holder
To mount a C mount lens.
Screw length from the lens mount surface shall be less than 6mm. And protruding portion of the lens shall be less
than 10mm.
②
. Image sensor / Optical filter
CMOS image sensor surface.
A dummy glass is attached on the surface of the sensor (VCC-5CL5M).
③
. Status LED
The LED lights when the camera is connected and power is turned ON.
④
. 6pins circular connector for external control
This is the connector to be used for trigger shutter operation or to supply power other than PoCL connector.
Usually, power is supplied via PoCL board, but this can be used when power is not enough or when you cannot
supply power from others. Trigger IN signal is electrically insulated.
Never supply power via both 6pins circular connector and camera link connector at the same time.
Input/Output circuit for external control
Trigger in terminal (TRIG_IN in the drawing) shall be capable of 10mA
～
20mA. And, 0.5mA
～
5mA shall be added to
EEN OUT terminal (EEN_OUT in the drawing) as load resistance for power (3.3V
～
20V).
1
2
3
4
5
6
HR10A-7R-6PB
(Hirose)
Pin No.
Signal Name
Description
1
Power IN
non-PoCL: Power Input (DC 12V typical)
2
NC
Not used
3
EEN OUT
Exposure Enable Output (Open Collector)
4
Trigger IN-
Trigger Input- (Isolated)
5
Trigger IN+
Trigger Input+ (Isolated)
6
GND
GND (for Pin 1)
