VCC-2CXP6R
Rev.905-0187-02
©2019 CIS Corporation. All rights reserved.
1
1.
Handling Precautions
1.1.
Camera Handling Precautions
□
Do not use or store the camera in the extremely dusty or humid places.
□
Do not apply excessive force or static electricity that could damage the camera.
Handle the camera with care.
□
Do not shoot direct images that are extremely bright (e.g., strong light source, sun, etc.). When strong light
such as spot light was shot, blooming or smear may occur. Put the lens cap on when camera is not in use.
□
Follow the instructions in
Chapter 3.3, “External Connector Pin Assignment”
for connecting the camera module.
Improper connection may cause damages not only to the camera module but also to the connected devices.
□
Confirm the mutual ground potential carefully before connecting the camera to monitors or computers. Any AC
leaks or coupling noises from the connected devices may cause damages or destroy the camera.
□
Do not apply excessive voltage. (Use only the specified voltage.) Unstable or improper power supply voltage
may cause damages or malfunction of the camera assembly.
□
Our warranty does not apply to damages or defects caused by irregular and/or abnormal use of the product.
1.2.
Restrictions on Applications
□
The camera must not be used for any nuclear equipment or aerospace equipment with which mechanical failure
or malfunction could result in serious bodily injury or loss of human life.
□
The camera must not be used under conditions or environments other than specified in this manual.
1.3.
Disclaimers (Exception Clause)
CIS shall be exempted from taking responsibility and held harmless for damages or losses incurred by the following
cases.
□
In case damages or losses are caused by earthquake, lightning strike, fire, flood, or other acts of God.
□
In case damages or losses are caused by deliberate or accidental misuse by the user, or failure to observe the
information contained in the instructions in this Product Specification and Operational Manual.
□
In case damages or losses are caused by repair or modification conducted by the customer or any unauthorized
party.
