CIS VCC-12CL1M, Техническое описание и руководство по эксплуатации

Страница: 22 / 30

VCC-12CL1M Rev. 900-795-35-00
©2016 CIS Corporation. All rights reserved.
22
□
At partial scan setting, the gamma correction, the binarization and the shading correction turn to be OFF.
□
At partial scan setting, the coordinates of a cursor are set to (0, 0).
□
When you switch between Full Frame Scan Mode and Partial Scan Mode or when you change Partial
setting, the setting may not be reflected as for the initial image after the change.
*Especially at fixed trigger shutter mode and pulse width trigger shutter mode, input the first as dummy
trigger and use the trigger from the second onward as actual video signal.
12.
Remote Communication Function
Via camera link cable, the camera can be controlled.
(1) The settings for RS232C
Baud rate : 9600bps / 115200bps
Data : 8bit
Stop bit : 1bit
Parity : None
XON/XOFF : Not controlled
* Either of Baud rates is settable as factory setting.
(2) Control code
・
The total control code conforms to ASCII code.
・
A control code consists of command, parameter and CR (0x0d). The change and acquisition of setting
parameters can be done by issuing commands from PC.
Command Parameter 1 Parameter 2 Function
GU Address None Obtain setting information
SU Address Data Change camera settings
As for the address and the data, please refer to “5. Function settings”.
(3) How to set a command
・ Input a command in capital letters
・
Separate between a command and a parameter by one space.
・
From the head of input character to the linefeed code [¥r]or[¥n] is analyzed as one command.
・
Input a remote controller data and a remote controller address by decimal.
・
The identifiable letters from the head are to be analyzed.
･
The returned command from the PC will be received by the camera, and then echoed back.
・
Refer to
“
Section 5. Function settings
”
for the address and data.
・
Do not input values and letters other than the specified above command and those mentioned in
“
Section 5.
Function settings
”
(4)
【
Example for Get Command
】
To get the information of the address 33
[Send]
GU[sp]33[¥r] or[¥n]
[Returned value] 50[¥r] [¥n] [Acquired data + Linefeed]
[Returned value] [¥r] [¥n] [Linefeed]
[Returned value] >[sp] [ Space]
[¥r]=CR(0x0D)
[¥n]=LF(0x0A)
[sp]=Space(0x20)