CIRRUS DESIGN CAPS, Руководство по компонентам

Страница: 33 / 48

12128-001
95-01
Page 25 15 Sept 2002
(f) Remove any shipping string securing rear harness bracket and rocket lanyard to para-
chute assembly.
CAUTION: Ensure forward harness is not twisted before attaching to three-point
shackle. Route harness so harness surface facing out at fuselage is facing
away from parachute assembly.
CAUTION: Do not pinch harness between spacer and three-point buckle.
(g) Install bolts, spacers, washers, and nuts securing forward harness straps to parachute
assembly three-point shackles. Install nuts on inboard side of shackles. Torque nuts to 95-
105 in-lbs (10.5 - 11.5 Nm).
(h) Lower parachute assembly into CAPS enclosure.
(i) Route parachute assembly retaining straps into upper slots of CAPS enclosure to facilitate
installation.
CAUTION: Ensure retaining straps are not twisted during installation.
(j) From baggage compartment, reach through access hole CB6 and route retaining straps
up, through bottom enclosure slots.
(k) Route retaining straps up, along parachute assembly, through buckle, over clasp, back
through buckle, and cinch tight.
CAUTION: Do not overtighten straps to point of overshooting and misaligning hook and
loop sewn to strap ends.
(l) Using a large, blunt, flat bladed screwdriver, further tighten retaining straps by inserting
screwdriver head into strap-end pocket and applying down force. Secure strap with hook
and loop sewn to strap ends.
CAUTION: Ensure blast-shield sleeve, sheathing the aft harness, is tucked behind 10°
bend in top of bracket before tightening bolts securing aft harness bracket to
222 bulkhead.
(m) Position aft harness bracket to 222 bulkhead so 10° bend in top of bracket faces away
from bulkhead and install bolts, washers, and nuts. Torque bolts to 330 - 370 in lbs (36.3 -
40.7 Nm).
(n) Install CAPS Cover. (Refer to 95-01)
(o) Install CAPS Rocket Assembly. (Refer to 95-01)
E. Caps Activation Handle and Cable Assembly (See Figure 95-018 and 95-019)
(1) Removal - Caps Activation Handle and Cable Assembly
(a) Acquire necessary tools, equipment, and supplies.
Description P/N or Spec. Supplier Purpose
Telescoping Magnet N/A Any Source Retrieval.
Small Knife N/A Any Source Facilitate Removal of
Attach Screws.