Ciro Mazzoni LOOP ANTENNA MIDI, Инструкция по эксплуатации

Страница: 8 / 41

52
How to install the
BABY LOOP
Provide suitable support by using a pole with a diameter from 50mm to 60mm
(2.0in– 2.3in) and a height from 1.5m to 2.5m (4,92ft-8,20ft), depending on the
surface upon which the mast is mounted.
However, if the surface is sloping, the antenna must be set higher than if the
surface is flat.
Please note that the surface upon which the mast is placed must not be made of
wood, fibreglass or plastic.
Run a 2-wire electrical cable with a minimum section of 0.75mm2 (18AWG) (for
distances up to 20
metres/65.62ft)
from the sealed housing of the antenna base to
the pin terminal block on the back of the controller.
If the distance between antenna and automatic controller exceeds 20 metres,
please see page 5 –
MOTOR CABLE
Run a coaxial cable (type RG213 or similar) from the SO connector on the pigtail
cable of the GAMMA MATCH antenna to the ANTENNA
connector on the back of
the automatic controller.
Now you can proceed to
the first turn on – page 75.
53
How to assemble the
midi LOOP
MIDI LOOP
packaging contents
Art. Description Quantity
0204
0206
0208
0210
0212
0218
Tubular section with flange and friction bearing
Tubular section with flange and variable capacitor
pack blades
Tubular section with flange, variable capacitor pack
blades and actuator
Tubular section with flange, base box and gamma
match
Mast clamp in stainless steel with hardware
Accessory box with:
1 Loop controller ATU
1 ATU power supply
1 USB keyboard for ATU
4 bolts M12x30
4 washers M12
1 stainless steel pivot pin 18x120
2 countersunk head hexagon socket drive screws M8x20
2 stainless steel washers M12
12 stainless steel bolts M8x40
12 stainless steel washers M8
12 stainless steel self locking nuts M8
1 stainless cap head hexagon socket drive screw M8x35
1 stainless steel self locking nuts M8 inox
1 anti-oxide paste
1 hex wrench ø5
1 hex wrench ø6
1 instruction manual
1
1
1
1
1
1