Circutor AFQm IP54, Инструкция по эксплуатации

Страница: 157 / 174

157
Instruction Manual
AFQm IP54
ENGLISH
Table 25 (Cont.): Modbus memory map: Filter parameters (Table 1).
Parameter Address Units
Temperature IGBT 4
(2) (3)
F5 ºC with 1 decimal
Temperature IGBT 5
(2) (3)
F6 ºC with 1 decimal
Temperature IGBT 6
(2) (3)
F7 ºC with 1 decimal
Temperature Inductor 3
(2) (3)
FB ºC with 1 decimal
Temperature Inductor 4
(2) (3)
FC ºC with 1 decimal
Phase L1 - L2 voltage DE V with 1 decimal
Phase L2 - L3 voltage DF V with 1 decimal
Phase L3 - L1 voltage E0 V with 1 decimal
Positive DC bus voltage E1 V with 1 decimal
Negative DC bus voltage E2 V with 1 decimal
(2)
For a system with devices in parallel, the parameter value is that of the device connected with RS-485.
(3)
Parameters only accessible for the 60A model.
Table 26: Modbus memory map: Filter parameters (Table 2).
Parameter L1 L2 L3 LN Units
Current in the filter A3 - A2 A5 - A4 A7 - A6 A9 - A8 [Hi] + [Low] A with 1 decimal
Phase – neutral voltage AA AB AC - V with 1 decimal
% of filter power used D8 D9 DA - %
Voltage THD BA BB BC - % with 1 decimal
Table 27: Modbus memory map: Filter parameters (Table 3).
Parameter Address Description
AFQm IP54
serial no.
(4)
2710 - 2711 Hi [10] + Low [11] serial no.
DSP software version 10C -
HMI software version 1C3 -
(4)
For a system with devices in parallel, the parameter value is that of the device connected with RS-485.
8.2.2.4.- AFQm IP54 filter messages
Table 28: Modbus memory map: Filter messages (Table 1).
Parameter Address
Device status
(5)
110
Bit Description Status
0x0001 Stop
1 : ON
0 : OFF
0x0002 Start
0x0004 Reset alarms
(5)
For a system with devices in parallel, the parameter value is that of the device connected with RS-485.
Table 29: Modbus memory map: Filter messages (Table 2).
Parameter Address
Alarm messages 105 (Hi value), 106 (Low value)
Bit Description
0x00000000 There are no alarms
0x00000002 L1 overcurrent alarm
0x00000004 L2 overcurrent alarm