2
www.imo.se
GA
0601.03 en-GB, ID-No.: 901930331, 161-490/A
These instructions are valid for all valves as specified in the
Valve identification chart
below.
Installation
BEFORE COMMENCING ANY WORK, READ THIS INSTRUCTION CAREFULLY!
Design limitations and technical data for each valve are found in the
Product description
.
Installation of IMO AB valves does not require special skills. However, these instructions presume that the
work is carried out by experienced fitters.
Failure to comply with these instructions
may cause damage and personal injury!
Valve identification
Valve
Size
Generation
Valve
Valid for
Comments
name
spring option
pressure
GAR
012
Threaded
034
pipe
100
connections
112
GAS
015
SAE
020
flanged
025
pipe
040
connections
GAD
065
DIN
flanged
pipe
connections
Identification of safety instructions
Non compliance of safety instructions
identified by the following symbol -
could affect safety for persons.
Safety instructions where
electrical safety is involved,
are identified by:
Safety instructions which shall be considered for
reasons of safe operation of the valve unit and/or
protection of the valve unit
itself are marked by the sign:
ATTENTION
01
T008
T040
T075
T100
A078
A308
A313
All work carried out on the valve has to be
performed in such a manner that risks for
personal injury are observed!
Transport and storage
Always protect the valve against ingress of water and other impurities. Store the valve in a clean, dry and
warm environment. The valve is delivered with the internals oiled and with protective covers over the pipe
connections. These covers should remain in place for as long as possible during the mounting and installa
-
tion procedure.
