Circor IMO AA3G Series, Руководство по обслуживанию

Страница: 3 / 15

A. GENERAL INSTRUCTIONS
Instructions found herein cover disassembly, assembly and parts identification of AA3G Series, Imo
pumps.
NOTE: Individual contracts may have specific provision that vary from this manual. Should any questions
arise which may not be answered by these instructions, refer to the General Instructions Manual,
CA-1, provided with your order. For further detailed information and technical assistance please
refer to Imo Pump, Technical Service Department at (704) 289-6511.
This manual cannot possibly cover every situation connected with installation, operation, inspection and
maintenance of equipment supplied. Every effort was made to prepare text of manual so that engineering
and design data is transformed into the most easily understood wording. Imo Pump must assume the
personnel assigned to operate and maintain supplied equipment and apply this instruction manual have
sufficient technical knowledge and are experienced to apply sound safety and operational practices which
may not be otherwise covered by this manual.
WARNING
If installation, operation and maintenance instructions are not correctly and strictly followed and
observed, injury to personnel or serious damage to pump could result. Imo Pump cannot accept
responsibility for unsatisfactory performance or damage resulting from failure to comply with instructions.
B. INTRODUCTION
Instruction manual covers series AA3G Imo Pumps. Series of pumps has been designed for general use
in lubricating, seal and distillate fuel oil applications. The size and construction of each pump is identified
in model number on the pump nameplate. Definitions of model designators are identified in Figure 1.
Figure 1 – Model Designator Definitions
1